Filter
Top Products
B.2 MODEL 24SII MEMORY MODULE
INSTALLATION
Each memory module provided by BayTech includes one of the
following modules: M24SII-M01 (0 to 4MB) or M24SII-M02 (0 to
16MB).
You will need the following equipment:
1 x phillips-head screwdriver
1 x 3/8 in. nut driver or socket
1. IMPORTANT: Remove power from the unit by depressing the
power switch on the front of the unit to OFF and also remove
power cord from socket.
2. Using the phillips-head screwdriver, remove the 4 phillips-head
screws holding the top cover of the unit. After screws are
removed, lift off cover.
3. Determine which type of memory module you are installing.
The 4MB memory module (part no. M24SII-M01) allows you to
upgrade the total memory to 4MB using 1MB zig zag in-line
packages (ZIPs). The 16MB memory module (part no. M24SII-
M02) provides buffer expansion up to 16MB using either 1MB x
8 or 4MB x 8 single in-line memory modules (SIMMs).
4. Determine the location where the new memory module will
install into. Refer to
Appendix D.2
. This mechanical layout
shows the location where the M24SII-M01 memory module
installs into which is marked
11
. If you are installing the
M24SII-M02 memory module, the location where it installs into
is adjacent to the location shown for the M24SII-M01 and is not
marked on the drawing.