Filter
Top Products
C.2 M24SII-M02 BUFFER EXPANSION
SIMM INSTALLATION
Each memory expansion upgrade kit provided by BayTech includes
either a 1MB x 8 or 4MB x 8 SIMM (single in-line memory module).
You may also use third party SIMMs. The total buffer size may range
from 0MB to 16MB with a minimum of 1MB required for operation.
Please use the following instructions when installing memory
expansion SIMMs.
You will need a phillips-head screwdriver.
1. IMPORTANT: Remove power from the unit by depressing the
power switch on the front of the unit to OFF. Also remove
power cord from socket.
2. Using the phillips-head screwdriver, remove the four
phillips-head screws holding the top cover of the unit. After
screws are removed, lift off cover.
3. With LED side of the unit facing you, look down into the unit
and locate the memory board. The memory board has four
sockets for memory expansion. These straight-line sockets are
marked
U15
,
U16
,
U17
and
U18
(refer to
Appendix D.5
-
M24SII-M02 Memory Board Assembly). Note that one or more
of these sockets may already have a memory module installed.
4. U15 must always be occupied by either a 1MB or 4MB SIMM.
Any new memory expansion module(s) may be installed in any
of the remaining sockets (i.e., U16, U17, or U18) and need not
be installed in any specific order.