Filter
Top Products
34
Revision page parameters
Parameter Descriptions
Box Version # Product version
FW Ver. Version of firmware installed in the digital sender.
FW Date Release date of the firmware installed in the digital sender.
HP JetDirect Prd. # Product number of the network interface card:
●
HPJ3113A
Ethernet (10Base-T) networks
HP JetDirect FW
Rev.
Version of firmware installed on the network interface card
(G.
xx.xx
).
MAC Address Unique LAN hardware address assigned to the network
interface card at the time of manufacture (for example,
0060B072525E).
IP Address Unique TCP/IP address of the network interface card. This is
assigned by the administrator.
Subnet Mask If subnets are used, the filter used to identify the subnet of the
HP JetDirect print server (network interface card). This is
assigned by the administrator.
TCP/IP status Status of the connection to the network:
●
INITIALIZING
The network interface card is searching for a valid IP address. After 2
minutes, a default IP address is automatically assigned.
●
READY
The network interface card has been assigned an IP address and is
actively connected to the network.
●
ERROR
A network or network interface card error has been detected.
Gateway Addr. IP address of the default gateway server used to communicate
with nodes on other subnets or networks.
Received pkts Total number of packets received without error.
Bad packets Total number of packets received with errors.
Framing err. Total number of packets received that contained a CRC (cyclic
redundancy check) or framing (alignment) error.
Transm. pkts Total number of packets transmitted without error on the
network.
Collisions Total number of packets that were not transmitted due to
successive collisions.
Late collisions Total number of packets that were not transmitted due to late
collisions (collisions after the 64th byte of a packet).