Filter
Top Products
50
Restoring the digital sender
Use this procedure:
●
After initializing the address books
●
After performing a Restore to factory defaults
●
When instructed to do so by HP Customer Support
Note
This procedure will erase any changes made to the address books and
configurations since a backup image was created.
To restore the digital sender
1
Make sure the computer you are using has the Backup and
Restore utilities installed.
2
At a command line, run Restore using the following syntax:
restore.exe/f:
Restore File
/d:
Digital Sender
/p:
Administrator Password
/l/tr
Note
Example: restore.exe /f:c:\data\data.tgz /d:xxx.xxx.xxx.xxx /
p:password /l /tr
Backup and Restore codes
Source Description
/dir Directory must be in a volume supporting long file names.
/d Digital sender network name or IP address.
/p Digital sender administrator password.
/l Log results in log file (backup.log or restore.log).
/tr Log low level activity in trace file (backup.trc or restore.trc).
/f Restore file, generated by previous backup.