Filter
Top Products
Removal and Installation
8-11
HP DesignJet 430, 450C and 455CA Printers
Removing the Right EndĆCover
Refer to figure 2.
Removal
1. Remove the top cover ' page 8Ć8.
2. Remove the Right Rollfeed Assembly ' page 8Ć9.
3. Pull the Printer on/off switch (item 1) out of the right endĆcover (item 2).
4. Release the three clips at the bottom of the right endĆcover: first the side
clip, then the front and back clips.
These may be stiff.
5. Pull the endĆcover up, taking care not to damage the frontĆpanel cables.
6. Inside the endĆcover, press the two tabs of the frontĆpanel towards each
other, and remove the frontĆpanel assembly from the endĆcover.
7. To be able to easily use the frontĆpanel, when the right endĆcover has been
removed, slide the frontĆpanel assembly onto the metal base of the Printer
as shown.