Filter
Top Products
4-22 Service Tests
HP DesignJet 430, 450C and 455CA Printers
Service Mode 2
Service Mode 2 contains tests that do need a complete initialization of the
Printer. This means if there is a system error in normal mode, it is NOT
possible to enter into Service Mode 2. If possible try entering into Service
Mode 1 and performing the tests there.
The tests in service mode 2 DO NOT send test information to the printer's
serial port. For some of the tests you will need to print the Service
Configuration Plot (Details ' page 4Ć29) in order to check the results.
Stopping a Test
The service tests are continuously repeated until you stop them. To exit a
test, press any of the frontĆpanel keys. To exit Service Mode 2, you must
power OFF the Printer.
Entering Service Mode 2
1 While holding the Media Source key down, switch the printer ON.
2 Once the the LEDs begin to light up one by one, release the Media
Source key.
The printer performs the electrical powerĆon tests and initializes the
mechanics as in normal user mode.
When you are in Service Mode 2, All the LEDs will go off except the ones
that have been selected. Once inside a test, all the LEDs, except for the
LEDs in the Error Group, will begin to flash.
Media Source
+
SERVICE MODE 2