Filter
Top Products
3-30 Troubleshooting and Diagnostics HP Omnibook 6000/6100
Unique Dock ID Sets whether the computer creates a unique hardware
profile for each dock (Enabled) or uses a common profile for
all docks (Disabled).
Enabled
UUID Displays the value of the 16-byte UUID (Universally Unique
ID) as 32 hex characters.
Detected
automatically
System Devices Menu Default
PS/2 Pointing Devices Disables the internal pointing devices when an external PS/2
mouse is connected.
Auto
External Fn Key Sets whether left CTRL+left ALT on an external keyboard is
interpreted as the Fn key.
Enabled
FDD Controller Enables the floppy drive. Enabled
Legacy USB Support Enables BIOS support for USB mouse, keyboard, and floppy
disk drive.
Enabled
Internal LAN Enables the internal (wired) LAN. Enabled
Mini PCI Slot 1 Enables the PCI slot normally used for a wireless LAN. Enabled
Mini PCI Slot 2 Enables the PCI slot normally used for a modem, which is
located under the cover on the bottom of unit. (Does not
affect Ambit modem.)
Enabled
Serial port Enables the serial port. Enabled
Base I/O address Sets the I/O address. 3F8h
Interrupt Sets the interrupt. IRQ4
Infrared port Enables the infrared port. Disabled
Mode Sets the hardware to support FIR (Fast IR) or SIR (Standard
IR) infrared communications.
FIR
Base I/O address Sets the I/O address. 2F8h
Interrupt Sets the interrupt. IRQ3
DMA channel Sets the DMA channel for Fast IR (FIR) mode. DMA0
Parallel Port Enables the parallel port. Enabled
Mode Sets the port to output only, bi-directional, EPP, or ECP. ECP
Base I/O address Sets the I/O address. 378h
Interrupt Sets the interrupt. IRQ7
DMA channel Sets the DMA channel for ECP mode. DMA1
Security Menu Default
User Password is Shows if a user password is set. Clear
Administrator Password
is
Shows if an administrator password is set. Clear
Set User Password Press ENTER to set, change, or clear the user password.
The password can have no more than 8 characters (0-9,
A-Z), and cannot include special or accented characters.
Enter
Set Administrator
Password
Press ENTER to set, change, or clear the administrator
password, which protects BIOS Setup settings. The
password can have no more than 8 characters (0-9, A-Z),
and cannot include special or accented characters.
Enter
Boot Sets whether a user password is required when the
computer boots. Requires the administrator password for
changes.
Enabled
Resume* Sets whether a user password is required when resuming
from Standby or Hibernate mode. Requires the administrator
password for changes. (Windows 98 only.)
Enabled