Filter
Top Products
Enclosure network configuration commands 101
SET SERIAL BAUD [ 9600 | 19200 | 38400 | 57600 | 115200]
• Description:
Configures the baud rate settings for the OA serial console port.
• Access level/Bay level:
OA administrator (only allowed from Active OA)
• Restrictions:
None
SET SNMP COMMUNITY
• Command:
SET SNMP COMMUNITY {READ | WRITE} "<community name>"
• Description:
Sets the community name for the read or write SNMP community. If a blank write community name is
given, then SNMP set commands are disabled until a non-empty community name is given.
• Access level/Bay level:
OA administrator, OA operator
• Restrictions:
o The write <community name> must be no more than 20 characters long, and the read <community
name> must be 1 to 20 characters long.
o All printable characters are valid.
o The default read community name is public.
o The default write community name is public.
SET SNMP ENGINEID
• Command:
SET SNMP ENGINEID "<engineid>"
• Description:
Sets the SNMPv3 engine ID for the enclosure. The final engine ID will be a hexadecimal string derived
from the <engineID> value.
Use the SHOW SNMP command to display the current engine ID.
• Access level/Bay level:
OA administrator, OA operator
• Restrictions:
o The <engineid> must be between 1and 27 characters in length. The final engine ID will be a
hexadecimal string derived from this value.
o Any local users must be deleted and recreated after changing the local engine ID.