Filter
Top Products
User account commands 28
REMOVE USER
• Command:
REMOVE USER {ALL | "<user name>" | CERTIFICATE "<user name>"}
• Description:
Removes a user from the system and/or any certificate mapped to the user. If you specify ALL, then the
command is run for all users except the default system accounts.
• Access level/Bay level:
OA administrator
• Restrictions:
o The <user name> is case sensitive.
o You cannot remove the Administrator account.
SET MINIMUM PASSWORD LENGTH
• Command:
SET MINIMUM PASSWORD LENGTH <length>
• Description:
Sets a minimum length for passwords. When set, a user's password must contain at least the number of
characters specified.
• Access level/Bay level:
OA administrator
• Restrictions:
o The minimum password length can be set between 3 and 40 characters.
o In FIPS Mode ON/DEBUG, the minimum password length can be set between 8 and 40 characters.
SET PASSWORD
• Command:
SET PASSWORD ["<password>"]
• Description:
Sets the password of the user that executed the command. If you do not provide a password on the
command line, you are prompted for one.
• Access level/Bay level:
All
• Restrictions:
o The <password> must be 3 to 8 characters long for firmware 1.00 through 1.30 and 3 to 40
characters long for firmware 2.00 and later. When in FIPS Mode ON/DEBUG, the password
length must be between 8 and 40 characters. The minimum password length setting may be
overwritten through the SET MINIMUM PASSWORD LENGTH command.