Filter
Top Products
Blade management commands 155
o
SET SERVER BOOT ONCE (on page 155) sets the boot device to be used on the next boot of the
bays specified.
• Access level/Bay level:
OA administrator, OA operator
Bay specific
• Restrictions:
o You must have access to the specified bay number.
o This command is not applicable to storage blades.
o This command is not applicable to HP Integrity server blades.
o The RBSU and NORMAL options are only available for SET SERVER BOOT ONCE.
o The USB option is only available for SET SERVER BOOT FIRST.
o This setting is only valid on present blades and cleared if the blade is removed.
o This version of Onboard Administrator firmware does not support boot options for servers
configured in UEFI boot mode.
SET SERVER BOOT FIRST
• Command:
SET SERVER BOOT FIRST {HDD | FLOPPY | PXE | CD} {ALL | <bay number> [{ - |
, } <bay number>]}
• Description:
o Stores a setting for the IPL to be passed to the specified servers at the next reboot.
o HDD sets the boot order of the blade to Hard Disk Drive, PXE.
o PXE sets the boot order of the blade to PXE, Hard Disk Drive.
o Sets the boot device to be used on the next boot of the bays specified.
• Access level/Bay level:
OA administrator, OA operator
Bay specific
• Restrictions:
o You must have access to the specified bay number.
o This command is not applicable to storage blades.
o This command is not applicable to HP Integrity server blades.
o This setting is valid only on present blades and is cleared if the blade is removed.
o This version of Onboard Administrator firmware does not support boot options for servers
configured in UEFI boot mode.
SET SERVER BOOT ONCE
• Command:
SET SERVER BOOT ONCE {NORMAL | HDD | FLOPPY | PXE | RBSU | CD} {ALL | <bay
number> [{ - | , } <bay number>]}