Filter
Top Products
Enclosure network configuration commands 96
SET ALERTMAIL SENDERNAME
• Command:
SET ALERTMAIL SENDERNAME "<name>"
• Description:
Sets the AlertMail sender's name. This name is attached to the email address in the from field in an
alertmail message.
• Access level/Bay level:
OA administrator, OA operator
• Restrictions:
o The <name> value may contain alphanumeric, dash(-), underscore(_), and space characters.
o Maximum length is 40 characters.
SET ALERTMAIL SMTPSERVER
• Command:
SET ALERTMAIL SMTPSERVER [ <host> ]
• Description:
Sets the SMTP server. This is the mail server where the Onboard Administrator delivers its e-mail based
events.
The <host> value can be either an IPv4 address, an IPv6 address, or a DNS name.
• Access level/Bay level
Administrator, OA operator
• Restrictions:
IPv6 addresses cannot specify the network prefix length.
SET FIPS MODE
• Command:
SET FIPS MODE {ON [“<password>”] | DEBUG [“<password>”] | OFF }
• Description:
o Using FIPS MODE ON enforces use of the Onboard Administrator in a FIPS 140-2-compliant mode,
using only FIPS 140-2 approved algorithms such as AES and TLSv1.2. Setting this option to OFF
also enables other SSLv3 algorithms such as RSA, RC4, and MD5.
o Using the DEBUG option sets the Onboard Administrator to a FIPS MODE ON similar environment.
FIPS MODE DEBUG has the functionality of FIPS MODE ON but is not considered FIPS-compliant
because of the debug option.
o The Onboard Administrator restarts after all changes are made.
o All existing settings are lost when this operation is run. Any change to the FIPS Mode setting
performs a Restore to Factory Default operation.