Filter
Top Products
Enclosure network configuration commands 91
ENABLE SLAAC
• Command:
ENABLE SLAAC
• Description:
Enables auto-configuration of IPv6 addresses from SLAAC messages for management interfaces of all
devices in the enclosure.
NOTE: For SLAAC addresses to be successfully configured, the ENABLE SLAAC setting must be
enabled on the enclosure. In addition, an IPv6 router must be configured on the enclosure
management network to provide the SLAAC addresses via Router Advertisements. iLOs may need
to be configured separately to obtain SLAAC addresses. To allow the necessary traffic on the
enclosure management network, both the ENABLE SLAAC and ENABLE IPV6 settings must be
enabled.
• Access level/Bay level:
OA administrator, OA operator
• Restrictions:
For the ENABLE SLAAC setting to take effect, IPv6 must be enabled. To enable IPv6, use the ENABLE
IPV6 (on page 90, "ENABLE EBIPAV6" on page 61) command.
ENABLE SNMP
• Command:
ENABLE SNMP
• Description:
Enables SNMP Trap support for the Onboard Administrator
• Access level/Bay level:
OA administrator, OA operator
• Restrictions:
None
ENABLE TELNET
• Command:
ENABLE TELNET
• Description:
Enables telnet access to the Onboard Administrator
• Access level/Bay level:
OA administrator, OA operator
• Restrictions:
You cannot enable TELNET in FIPS Mode ON/DEBUG.