Filter
Top Products
Enclosure network configuration commands 93
REMOVE OA DNS
• Command:
REMOVE OA DNS [<OA bay number>] <ip address>
• Description:
Removes the IP address of a DNS server from the list for the specified Onboard Administrator.
The DNS servers are used only if the system is configured to use a static IP address.
If no bay number is provided, the command default to the active Onboard Administrator.
• Access level/Bay level:
OA administrator, OA operator
• Restrictions:
The <ip address> must be in the form ###.###.###.###, where each ### ranges from 0 to 255.
REMOVE OA DNS IPV6
• Command:
REMOVE OA DNS IPV6 {<OA bay number>} <ipv6 address{/prefix length}>
• Description:
Removes the specified DNS IPv6 address from the list of DNS addresses for the specified Onboard
Administrator. If a bay number is not specified, then the command defaults to the active Onboard
Administrator.
• Access level/Bay level:
OA administrator, OA operator
• Restrictions:
o A maximum of two DNS servers can be added.
o The <ip address> must be in the form ####:####:####:####:####:####:####:#### or
####:####:####:####:####:####:####:####/### (with a prefix), where each #### ranges
from 0 to FFFF and the prefix /### ranges from 0 to 128.
REMOVE SNMP TRAPRECEIVER
• Command:
REMOVE SNMP TRAPRECEIVER <host> {"<community name>"}
• Description:
o Removes an IP address from the list of systems that receive SNMP traps. If the same IP address is
listed multiple times with different communities, all instances of the IP address disappear unless
<community> specifies which one is to be removed.
o Removes an existing trap receiver from the SNMP configuration. If the same <host> is listed multiple
times with different communities, all instances of the <host> disappears unless <community name>
specifies which one is to be removed.
o The <host> value can be either an IPv4 address, an IPv6 address, or a DNS name.