Filter
Top Products
Example 5-4 Using mptutil to Display Detailed SCSI Information and VPD for an Adapter
# mptutil /dev/mpt14
******************************************************************************
**** ****
**** M P T U T I L S u p p o r t T o o l ****
**** ****
**** for Ultra320 SCSI Controller ****
**** ****
**** Version 1.02 : Oct 22 2006 ****
**** ****
**** (c) Copyright 2003 Hewlett-Packard Development Company, L.P. ****
**** ****
******************************************************************************
---- ADAPTER INFORMATION -----------------------------------------------------
Device File : /dev/mpt14
Hardware Path : 1/0/14/0/0
Driver Version : r11.31/1.02
---- CHIP INFORMATION --------------------------------------------------------
Device ID : 0x0030
Vendor ID : 0x1000
Revision ID : 0x8
Subsystem ID : 0x12c5
Subsystem Vendor ID : 0x103c
IOC Number : 0
Max. Devices : 16
Number of channels : 2
Driver State : OPERATIONAL
---- FIRMWARE INFORMATION ----------------------------------------------------
SCSI Firmware Version : 1.03.35.69 IO
SCSI Firmware Version (Hex) : 1.03.23.45 IO
SCSI Firmware Size : 40356
EFI Driver Version : 1.05.00.01
---- V P D I N F O R M A T I O N -------------------------------------------
Adapter : PCI-X DUAL CHANNEL ULTRA320 SCSI ADAPTER
Part Number : A6961-60011
Engineering Code : C-4429
Specification : PW=15W PCI-X=64BIT,133MHZ
Serial Number : P105283605
Manufacturing Date Code : C-4429
EFI driver version : 1.05.00.01
The Driver State line in the CHIP INFORMATION section contains important information.
The following driver states are defined in the Driver State field:
UNINITIALIZED
This state indicates that the hardware has not been initialized by the driver.
This state could result if the driver was unable to successfully initialize the
channel.
OPERATIONAL
This state indicates that the driver is online and ready to perform normal
SCSI I/O operations.
TASK_MGMT
This state indicates that driver is currently performing task management
commands such as SCSI BUSRESET, ABORT TASK, and BUS DEVICE
RESET.
REPAIRING
This state indicates that the driver has detected a controller fault and is
currently recovering from that condition.
CONFIGURING
This state indicates that the controller initialization is complete. The driver
is in the process of retrieving and setting various configuration parameters.
Using the mptutil Command 57