HP (Hewlett-Packard) C5J37AWABA Personal Computer User Manual


 
Hood sensor
The hood sensor is located on the bottom left of the computer (when viewed from behind).
Figure 6-90 Hood sensor location
To remove the hood sensor:
1. Prepare the computer for disassembly (see
Preparing to disassemble the computer on page 27).
2. Prepare the computer for disassembly (see
Preparing to disassemble the computer on page 27).
3. Remove the access panel (see
Access panel on page 34).
4. Remove the stand (see
Stand on page 36).
5. Remove the lower panel (see
Lower panel on page 38).
6. Remove the side panels (see
Side panels on page 76).
7. Remove the metal plate (see
Metal plate on page 39).
8. Remove the power supply (see
Power supply on page 78).
9. Remove the system board (see
System board on page 81).
10. Remove the front bezel (see
Front bezel on page 92).
11. Remove the display panel (see
Display panel on page 97).
12. Disconnect the hood sensor cable from the system board connector labeled HSENSE.
Hood sensor 103