HP (Hewlett-Packard) C5J37AWABA Personal Computer User Manual


 
System board
The system board is located on the right side of the computer (viewed from the rear). It is secured
with eight Torx screws.
To remove the system board:
1. Prepare the computer for disassembly (see
Preparing to disassemble the computer on page 27).
2. Remove the access panel (see
Access panel on page 34).
3. Remove the stand (see
Stand on page 36).
4. Remove the lower panel (see
Lower panel on page 38).
5. Remove the memory modules (see
Memory on page 48).
6. Remove the graphics heat sink (see
Graphics heat sink on page 63).
7. Remove the processor heat sink (see
Processor heat sink – model 6300 on page 64).
8. Remove the processor (see
Processor on page 67).
9. Remove the WLAN module (see
mSATA Solid-State Drive on page 68).
10. Disconnect all cables from the system board, noting their location for reinstallation.
System board 81