HP (Hewlett-Packard) C5J37AWABA Personal Computer User Manual


 
Stand
The stand is secured with two captive Torx screws. You must remove a plastic cover to gain access
to the screws. You must remove the access panel to remove the stand.
To remove the stand:
1. Prepare the computer for disassembly (see
Preparing to disassemble the computer on page 27).
2. Remove the access panel (see
Access panel on page 34).
3. Push the release button (1) on the bottom of the stand and pull the back of the stand off (2).
Figure 6-14 Removing the back of the stand
4. Push the base of the stand down (1), and loosen the two captive Torx screws securing the stand
to the chassis (2).
Figure 6-15 Releasing the stand
36 Chapter 6 Removal and Replacement Procedures All-in One (AIO) Chassis