Filter
Top Products
Removal and replacement procedures 20
1.
Power down the server (on page 16).
2. Use the T-15 Torx screwdriver to eject the drive, and pull the drive out of the server.
NOTE: The T-15 Torx screwdriver is shipped with the server and can be located on the rear panel ("Rear
panel components" on page 73).
To replace the component, reverse the removal procedure.
Removing the processor module
NOTE: Refer the section "Processor module LEDs (on page 72)" for information on the current processor
and PPM status.
1. Power down the server (on page 16).
2. Remove the shipping bracket, if applicable.
NOTE: The shipping bracket is located near the processor module lever, and is marked with an orange tab
for easy identification.