Filter
Top Products
Removal and replacement procedures 26
3.
Remove the PPM.
IMPORTANT: Always install a PPM when you install a processor. The system fails to boot if the
corresponding PPM is missing.
To replace the component, reverse the removal procedure.
Removing a PCI latch
1. Power down the server (on page 16).
2. Extend or remove the server from the rack ("Remove the server from the rack" on page 16).
3. Remove the access panel ("Removing the access panel" on page 17).
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all
expansion slots have either an expansion slot cover or an expansion board installed.
4. Open the latch.
5. Remove the expansion board from the slot, if installed ("Removing a PCI-X Hot Plug expansion
board" on page 47).
6. Remove the expansion slot cover from the slot, if installed.