Filter
Top Products
Removal and replacement procedures 40
6.
Open the latch, and lift the memory backplane from the server.
To replace the component, reverse the removal procedure.
Removing a hard drive blank
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays
are populated with either a component or a blank.
Remove the hard drive blank by squeezing the release buttons, and pulling the blank from the server.
To replace the component, reverse the removal procedure.
Removing a hot-plug SCSI hard drive
CAUTION: Always power down the server if the boot partition resides on the drive you are replacing or if
you are replacing the only drive in the server.