Filter
Top Products
To install the HP-UX VXIplug&play drivers for the HP E1432A
(for HP-UX systems):
1 Log in as root.
2 Insert the HP E1432A CD_ROM into the CD-ROM drive or obtain the latest HP
E1432A distribution.
3 Type swinstall.
See the HP-UX Reference manual for information on the swinstall command.
The HP E1432A distribution is normally installed in the
/opt/vxipnp/hpux/hpe1432/ directory. The files have extensions such as .h,
.fp, .sl, and .hlp.
The Resource Manager
The Resource Manager is a program from your hardware interface
manufacturer. It looks at the VXI mainframe to determine what modules
are installed. You need to run it every time you power up. If you get the
message: “No HP E1432A can be found in this system,” then run the
Resource Manager.
Before running the HP E1432A software make sure that your hardware is
configured correctly and that the Resource Manager runs successfully.
Before using your measurement system, you must set up all of its devices,
including setting their addresses and local bus locations. No two devices
can have the same address. Usually addresses 0 and 1 are taken by the
Resource Manager and are not available.
For more information about the Resource Manager, see the documentation
with your hardware interface.
HP E1432A User's Guide
Getting Started With the HP E1432A
2-6