Filter
Top Products
Upon entering the ARM state the HP E1432A starts saving new data in its
FIFO. It remains in the ARM state until the Sync/Trigger line goes high. If
the HP E1432A is programmed with a pre-trigger delay, it collects enough
data samples to satisfy this pre-trigger delay, and then releases the
Sync/Trigger line. If no pre-trigger delay has been programmed, it releases
the Sync/Trigger line immediately. When all modules in a system have
released the Sync/Trigger line (allowing it to go high), a transition to the
TRIGGER state occurs.
Upon entering the TRIGGER state the HP E1432A continues to collect data
into the FIFO, discarding any data prior to the pre-trigger delay. The HP
E1432A remains in the TRIGGER state until it sees a high-to-low transition
of the Sync/Trigger line. The Sync/Trigger line is pulled low by any HP
E1432A which encounters a trigger condition and is programmed to pull the
Sync/Trigger line. If any HP E1432A is programmed for auto triggering
(with e1432_set_auto_trigger), the Sync/Trigger line is pulled low
immediately. The Sync/Trigger line may also be pulled low by an explicit
call to the function e1432_trigger_measure.
Upon entering the MEASURE state the HP E1432A continues to collect
data. The HP E1432A also presents the first data from the FIFO to the
selected output port, making it available to the controller to read. The HP
E1432A holds the Sync/Trigger line low as long as it is actively collecting
data. In overlap block mode the HP E1432A stops taking data as soon as a
block of data has been collected, including any programmed pre- or
post-trigger delays. (It starts again when another trigger occurs). In
continuous mode, the HP E1432A stops taking data only when the FIFO
overflows. When data collection stops, the HP E1432A releases the
Sync/Trigger line. When all HP E1432As are finished and the Sync/Trigger
line goes high, the HP E1432A goes into the IDLE state again.
The measurement initialization and loop may be interrupted at any time
with a call to e1432_reset_measure, which puts the module in the TESTED
state.
Register-based VXI Devices
The HP E1432A is a register-based VXI device. Unlike message-based
devices which use higher-level programming using ASCII characters,
register-based devices are programmed at a very low level using binary
information. The greatest advantage of this is speed. Register-based
devices communicate at the level of direct hardware manipulation and this
can lead to much greater system throughput.
You will not need to access the registers in order to use the HP E1432A.
The HP E1432A’s functions can be more easily accessed using the HP
E1432A Host Interface Library software. However, if you want more
information about the registers see Appendix A: Register Definitions.
HP E1432A User's Guide
The C-Language Host Interface Library
4-21