Filter
Top Products
SECTION 2
INSTALLATION & SETUP
Setting up the Feed System
The printer is equipped with four sheet separators, two media side guides, a rear media guide, and a media
thickness adjustment knob.
Sheet Separation Adjustment
Figure 14
The sheet separators are adjusted individually as follows:
1. Move the side guides so that the separator locking
knobs are accessible.
2. Loosen each Separator Locking Knob, as shown in
Figure 14, and raise each separator, then tighten the
locking knob to hold the separator in the up position.
3. Place a single piece of media under the separators. It
is best to place the media so it is center on the table.
4. Loosen the Separator Locking Knob. Let the
separator fall onto the media and tighten the locking
knob as shown in Figure 15. Repeat for each
separator that has media under it.
IMPORTANT! Be sure that unused separators are
locked in their raised position. If not, they will rub on
the feed rollers, causing transport problems and or
damage to the rollers and separators.
Figure 15
Media Side Guide Adjustment
1. Adjust the Media Side Guides so that they are about a dimes width (~1/32-inch) from the sides of
the media. Tighten the locking screws on the side guides to secure their positions.
Figure 16
Envelope Imager 1.5/1.5+ Operations Rev. 6/7/2007
15