Filter
Top Products
2-2 HP Surestore FC 1Gb/2Gb Switch 16B Installation and Reference
Installing and Configuring the HP Surestore FC 1Gb/2Gb Switch 16B
2
additional equipment or ballast, the equipment rack must be anchored to the building
structure before operation.
Package Contents
The major items contained in the FC 16B shipping carton(s) include the following items:
• One FC 16B switch, two fan trays, and one or two power supplies installed
• One 10 ft. RS-232 serial cable (convertible to an RJ-45 connector through removal of
the adapter on the end of the cable)
• Two 6 ft. power cables (according to the number of power supplies included with the
switch)
• Four rubber mounting feet (used only for setting up the switch as a stand-alone unit)
• Two rails and one bag of rail mounting hardware (required if the switch is to be
installed in a rack):
• hp surestore FC 1Gb/2Gb Switch 16B Quick Start Guide
• HP Surestore FC 1Gb/2Gb Switch 16B Documentation CD-ROM
Installing the Switch as a Stand-Alone Unit
This section provides instructions for setting up the switch as a stand-alone unit on a flat
surface. The following items are required:
•FC 16B
• Power cables
• Rubber mounting feet
To set up the switch as a stand-alone unit:
1. Check contents of the shipping carton to verify all the required parts and hardware are
available.
2. Apply the rubber feet by completing the following steps:
CAUTION Installing the rubber feet on the switch is recommended to help prevent the
switch from accidentally sliding off the supporting surface.
a. Clean the four depressions that are at each corner of the bottom of the switch to ensure
they are free of dust.
b. Place a rubber foot in each depression, with the adhesive side against the chassis, and
press into place.
3. Place the switch on a flat, sturdy surface.