Filter
Top Products
2-10 HP Surestore FC 1Gb/2Gb Switch 16B Installation and Reference
Installing and Configuring the HP Surestore FC 1Gb/2Gb Switch 16B
2
– In a Windows 95, 98, 2000, or NT environment:
– In a UNIX environment, enter the following string at the prompt:
tip /dev/
ttyb -9600
f. From the terminal emulator application, log on to the switch with administrative
privileges through the serial connection. The default administrative logon is
admin
and the default password is
password.
CAUTION Do not change the default password unless local administration policy
requires it.
g. Enter the following at the prompt:
ipAddrSet
h. Enter the following information at the corresponding prompts, listed below:
–
Ethernet IP Address [10.77.77.77]: Enter the new Ethernet IP address.
–
Ethernet Subnetmask [0.0.0.0]: Enter the new Ethernet subnetmask.
–
Fibre Channel IP Address [none]: Enter the new Fibre Channel IP
address if desired.
–
Fibre Channel Subnetmask [none]: Enter the new Fibre Channel subnet
mask if desired.
–
Gateway Address [172.17.1.1]: Enter the new gateway address.
–
Set IP address now? [y = set now, n = next reboot]: Enter “y”
to set now.
i. You can verify the address was correctly set by entering the following:
ipAddrShow
j. Record the IP address on the label provided for this purpose on the FC 16B.
k. Once the IP address is verified as correct, remove the serial cable and replace the
shipping plug in the serial port.
Note The serial port is intended only for use during the initial setting of the IP
address and for service purposes. Using the serial port during normal switch operation
or for regular maintenance is not recommended.
Parameter Value
Bits per second: 9600
Databits: 8
Parity: None
Stop bits: 1
Flow control: None