Filter
Top Products
HP Surestore FC 1Gb/2Gb Switch 16B Installation and Reference Guide 2-5
Installing and Configuring the HP Surestore FC 1Gb/2Gb Switch 16B
2
To install the switch in a rack:
1. Check contents of the shipping carton to verify all the required parts and hardware are
available.
2. Choose a mounting location in the rack for the switch.
3. Attach the rear rail-tray brackets to the rear rack uprights by completing one of the
following steps:
– For an HP rack, install each of the two mounting brackets with (1) M5 Torx head
screw with captive lock washers as shown in Figure 2-2.
Figure 2-2. Installing the Rear Rail-Tray Brackets (HP Rack)
– For a Compaq/Rittal rack, assemble each of the two brackets with (2) spacers, (2)
M5 flat washers, and (1) M5 Torx head screw with captive lock washers as shown
in Figure 2-3. Note that the alignment pins will be resting on the top surfaces of the
spacers.
Figure 2-3. Installing the Rear Rail-Tray Brackets (Compaq/Rittal Rack)
4. Install the Tinnerman clips or nuts by completing one of the following steps:
– For an HP rack, install (2) M5 U-type Tinnerman clips for each of the front columns
of the rack in the top and bottom positions of the three-hole EIA pattern as shown in
Figure 2-4.