Filter
Top Products
Runtime switching software default settings 39
Runtime switching software default settings
This section provides the default settings for the GbE2 Interconnect Switch:
• Table 12 contains general default settings for both Switch A and Switch B
• Table 13 contains port names, VLANs, STP, trunking default settings for Switch A and Switch B
Switch A and Switch B: general default settings
Switch A and Switch B are configured with the following general default settings:
Table 12 Switch A and Switch B: general default settings
Setting Value
Notice None
Banner None
User Names/Passwords User Name:
• user—Enabled
• oper—Disabled
• admin—Enabled (cannot be
disabled)
Password:
• user
• None
• admin
BOOTP Service Enabled
IP Address (if manual IP option is
selected)
0.0.0.0
Subnet Mask (if manual IP option is
selected)
0.0.0.0
Primary Default Gateway 0.0.0.0
Secondary Default Gateway 0.0.0.0
Primary DNS Server Address 0.0.0.0
Secondary DNS Server Address 0.0.0.0
Default Domain Name None
Management Network/Mask 0.0.0.0/0.0.0.0
Switch Software Image on Next Boot Image1
Switch Config File on Next Boot Active
Display Hostname (sysName) in CLI
Prompt
Disabled
Idle Timeout 5 minutes
Telnet Status Enabled
Telnet Port 23
Web Status Enabled
Web Port 80
Backpressure Disabled
Port State Enabled
Port Speed/Duplex Auto
Flow Control Receive & Transmit
STP STG 1—Enabled with Default VLAN (VID=1)
Port 1-16 (Server Ports) STP—Disabled at Port Level
STG 2-16—Disabled
Bridge Max Age 20 seconds