Filter
Top Products
Chapter 5 351
Command Definitions L-O
LISTLOG
LISTLOG
Lists currently active logging identifiers on the system and whether automatic log file
changing has been enabled.
Syntax
LISTLOG[ logid[ ;PASS] ]
Parameters
logid The specific logging identifier to be verified. Default is to list all currently
active logging identifiers on the system.
PASS Causes the password associated with the logging identifier to be displayed.
This option can be used only by the creator of the logging identifier.
Operation Notes
This command lists the logging identifier specified with its associated creator and log file.
The column labeled CHANGE indicates whether the CHANGELOG command is permitted;
that is, whether the name of the first logging file ends in 001 and thus follows the naming
convention required by the CHANGELOG command. The column labeled AUTO indicates
whether an automatic CHANGELOG is permitted; that is, whether the AUTO parameter has
been specified with a GETLOG or ALTLOG command.
If the logid parameter is not entered, all logging identifiers on the system are displayed
with their creators and log files. The PASS parameter, which can be used only by the
creator of the logging identifier specified, causes the password associated with the logging
identifier to be listed.
Use
This command may be issued from a session, job, program, or in BREAK. Pressing Break
has no effect on this command. System supervisor (OP) or user logging (LG) capability is
required to use this command.
Example
To list all logging identifiers on the system, enter:
LISTLOG
LOGID CREATOR CHANGE AUTO CURRENT LOGFILE
TESTLOG LALITHA.MPEM YES YES LAL001.PEJ
TEST1 MARK.MPEM YES NO M001.KSAM3
TEST2 PAT.MPEM NO NO TEST.ALVAR