Filter
Top Products
1. Stop all running instances of Insight Control server deployment services.
2. Uninstall any previous installation instances of Windows Automated Installation Kit (WAIK)
versions 1.0 and 2.0.
3. Download and install WAIK version 3.0 for Windows 7 from the Microsoft Download Center
at: http://www.microsoft.com/en-us/download/details.aspx?id=5753.
4. To make DISM tool available for the App Server, perform one of the following:
• Update the hpmmsvc.conf file (<ICMigr Installation Path>\bin\windows\) to add
set.Path=<>;<WAIK Installation Path>\Tools\Servicing, and then restart
the server migration services.
• Add the windows PATH environmental variable with the - <WAIK Installation
Path>\Tools\Servicing parameter.
5. To verify and view that DISM version 6.1 is installed, go to the Upload Drivers tab of the server
migration wizard.
Source preparation
Corrective action is required before this server can be migrated
The following message appears when an affected system is detected during the launch of the
source server agent:
ATTENTION:Corrective action is required before this server can be
migrated.
Cause
Some versions of Windows Server 2003 that are preinstalled by HP cannot be migrated successfully
unless you perform corrective action before attempting the migration. The server migration Source
Agent detects affected systems during initialization. If the system is affected, instructions for
performing the corrective action are provided. If you attempt the migration without first performing
the corrective action, your destination server becomes nonbootable.
NOTE: The server migration Source Agent will not detect whether the corrective action has already
been performed. Subsequent attempts to execute this agent will indicate that corrective action is
still required. However, the corrective action must be applied only once.
Suggested action
Perform the following:
1. Cancel execution of the migration agent.
2. In the command prompt window, change to the root directory of the Windows disk.
3. Run the following command: SFC /SCANNOW. This command might take several minutes. For
more information about this command, see the following website:
http://support.microsoft.com/kb/310747/en-us
Source server identification fails
The source server identification fails during the first step of the migration wizard.
Suggested action
1. Verify the identifier entered. If the name is entered for a source server that is in a domain, be
sure that the Fully Qualified Domain Name (FQDN) is entered.
2. Verify that the migration agent has been installed on the identified source server. For more
information about running the migration agent, see server migration online help.
Source preparation 51