Filter
Top Products
Out of memory error occurs on the application station during migration
The Insight Control application station requires a minimum of 1024 MB of free memory for Insight
Control migrations.
Suggested action
Free memory or add memory to the application station, and then restart the migration.
Destination server boots with an invalid IP address
After a P2P migration, the destination server might boot with an invalid IP address (for example,
169.x.x.x), instead of using the IP address that was configured through the migration wizard.
Cause
This issue occurs if the destination IP address configuration fails or Dynamic Host Configuration
Protocol (DHCP) is not enabled in the network. Whenever a NIC is added to the server, by default
the NIC is assigned an IP address using the DHCP configuration. If no DHCP server is configured
on the network, the server will boot with an invalid IP address.
Suggested action
After the P2P migration is complete, manually configure the IP address on the destination server.
For specific instructions on performing this task, see the help files for the specific OS documentation.
Windows server migration Source Agent or PINT remote deployment is intermittent
and deployment fails with a General failure occurred error
When you remotely deploy the Windows server migration Source Agent or PINT from the Insight
Control server migration application station or from Systems Insight Manager, server migration
Source Agent deployment fails with the error General failure occurred. In addition, the
<Insight Control server migration Installation
Folder>\log\AgentLogs\hp\log\<source IP>\timestamp_smp_log.txt file displays
the following exception:
Received Target Exception: UnknownException : SoapSession::SoapSession : unknown exception!
No install was run, due to connection error
Suggested action
Manually install the server migration Source Agent or PINT on the source server.
Unable to detect HP FlexFabric 10Gb 2-port 554FLR-SFP+ Adapter configured as
iSCSI disk in step 5 of migration wizard
When you start a P2P migration of any of the OS from any server to DL385p Gen8 with HP
FlexFabric 10Gb 2-port 554FLR-SFP+ Adapter configured as iSCSI disk and then start an auto
boot in step 3, you will observe that the adapter is not detected in step 5 of migration wizard and
the following error message is displayed:
"HP Insight Control could not find any disks on destination server"
Suggested action
You must disable IOMMU in RBSU (System Config > Processor Settings > AMD–Vi).
HP Smart Array B320i controller name is not displayed
When you perform X2P migration to Gen8 server having HP Smart Array B320i as primary
Controller, you will observe that the name of controller is not displayed in step 5 and 7 of the
migration wizard.
64 Troubleshooting