Filter
Top Products
Suggested action
Try the following:
1. During the Specify destination disks and Resize NTFS partitions step of the migration wizard
process, in the Assign Disks and Resize NTFS Volumes table, modify the disk size in the
Destination Size field to match the value shown in the Source Size field.
NOTE: After you modify the Destination Size field to match the Source Size field, the Minimum
Destination Size field will display 1 MB more than the Minimum Destination field.
2. Complete the rest of the steps to finish the migration process. The migration will successfully
finish.
Migration fails during the disk cloning phase
The following message might appear on the application station log (hpsmpsvc.log) if the
destination server disk has a Windows Logical Partition configured on it:
com.hp.mx.smp.vmdisk.api.APIException: Not enough space for partition!
Cause
An existing disk that already contains some Windows partitions is being used as the destination
for migration.
Suggested action
To resolve the issue, format the destination disk before you use it as a destination disk.
1. Reboot the destination server and press F9 to enter the BIOS settings of the destination server.
2. In the Advanced Options section, select Erase Boot Disk.
3. Rerun the migration process.
Failed: Drivers could Not Be Injected Into Boot Disk in the logs
Migration fails with the message Failed: Drivers could not be injected into boot
disk... and the iSCSI mounting error The target has already been logged in via
an iSCSI session appears in the log files.
Suggested action
Restart the application station and retry the migration.
Starting a new migration after a current migration is stopped
If a migration is stopped by means other than a cancellation or failure, the application station,
source server, and destination server might not recognize that the migration has stopped.
Suggested action
To start a new migration:
1. Restart the migration agent on the source and destination servers.
2. On the application station, close the migration wizard.
3. Restart the Insight Control application service and the Insight Control server migration Web
Service.
4. Reopen the migration wizard.
Unrecoverable sector-read errors on the source server hard drive are not supported
and fail a Windows P2P or P2V migration
The following error message might appear if a volume that has unrecoverable sector-read errors
is migrated: Server Migration failed. ReadFile failed.
62 Troubleshooting