Filter
Top Products
Manually configure IPv4 TCP/IP parameters from the control panel
Use the control-panel Administration menus to manually set an IPv4 address, subnet mask, and
default gateway.
1.
At the control panel, press the Home
button.
2. Open each of the following menus:
●
Administration
●
Network Settings
●
Jetdirect Menu
●
TCP/IP
●
IPv4 Settings
●
Config Method
●
Manual
●
Manual Settings
●
IP Address, Subnet Mask, or Default Gateway
3. Use the numeric keypad, or press the up arrow
or the down arrow to increase or decrease
the number for the first byte of the IP address, subnet mask, or default gateway.
4. Press the OK button to move to the next set of numbers. To move to the previous set of numbers,
press the back arrow
.
5. Repeat steps 3 and 4 until the IP address, subnet mask, or default gateway is complete, and then
press the OK button to save the setting.
68 Chapter 5 Connect the product with Windows ENWW