Filter
Top Products
Technical Reference Guide www.hp.com 5-3
Input/Output Interfaces
5.2.2 eSATA interface
These systems provide a SATA/eSATA port (connector P64 on the system board) that can
support an external SATA (eSATA) storage device. The eSATA interface provides higher
bandwidth than USB 2.0 and Firewire (1394) interfaces.
An optional bracket/cable assembly (Figure 5-2) is required to attach an eSATA device to the
system.
Figure 5-2. Optional eSATA Bracket/Cable Assembly.
The following operating parameters of the eSATA interface can be set in the ROM-based Setup
utility:
■ Transfer speed: 1.5 or 3 Gbps (default set to 1.5 Gbps for reliability)
■ Emulation mode: IDE, AHCI, or RAID (default set to AHCI)
■ Port availability: Available or Hidden (default set to Available)
In the IDE or AHCI modes, the system BIOS ROM controls the hard drives and Removeable
Media Boot setting applies. In the RAID mode, the RAID option ROM controls the hard drives
and the Removeable Media Boot setting does not apply.
For hot-plug functionality, the eSATA port must be set to the AHCI or RAID mode and an AHCI
driver with hot-plug support must be loaded onto the system. This driver is pre-loaded on
systems as shipped from the factory. If the system is wiped clean or the Windows OS is
re-installed, the AHCI driver can be loaded by installing the OS while the eSATA emulation
mode is set to AHCI.