Filter
Top Products
A-4 www.hp.com Technical Reference Guide
Error Messages and Codes
1785-MultiBay incorrectly installed For integrated MultiBay/ USDT systems:
MultiBay device not properly seated.
or
MultiBay riser not properly seated.
1794--Inaccessible device attached
to SATA 1
(for systems with 2 SATA ports)
A device is attached to SATA 1. Any device attached to this connector
will be inaccessible while “SATA Emulation” is set to “Combined IDE
Controller” in Computer Setup.
1794-Inaccessible devices attached
to SATA 1 and/or SATA 5 (for
systems with 4 SATA ports)
A device is attached to SATA 1 and/or SATA 5.
Devices attached to these connectors will be inaccessible while “SATA
Emulation” is set to “Combined IDE Controller” in Computer Setup
1796-SATA Cabling Error One or more SATA devices are improperly attached. For optimal
performance, the SATA 0 and SATA 1 connectors must be used before
SATA 2 and SATA 3.
1801-Microcode Patch Error A processor is installed for which the BIOS ROM has no patch.
Check for ROM update.
1803-Processor feature set is
insufficient
Processor cannot support current systems settings (processor
does not support TxT)
1804-Processor feature set and
memory configuration are
incompatible
Incompatible memory configuration (TxT enabled and systems
has more than 4GB of memory)
2201-MEBx module did not
checksum correctly
Corrupt MEBx
2203-Setup error during MEBx
execution
Corrupt MEBx
2204-Inventory error during
MEBx execution
AMT inventory failed
2205-Interface error during
MEBx execution
HECI interface failed
2207-AMT connection error
during MEBx execution
AMT settings
2208-Timeout Error MEBx timed out
2209-USB Provisioning Error MEBx provisioning failed
2210-Parameters Frame Error MEBx parameters frame error
Table A-2. (Continued)
Power-On Self Test (POST) Messages
Error Message Probable Cause