Filter
Top Products
NetMail/3000 Menu Interface
Users Guide
2-97
Special Terminal Types
If you need to run NetMail/3000 and you are connecting to the HP3000 over an X.25 net-
work or use a terminal type other than the default (termtype 10), you will notice that NetMail/
3000 treats your terminal as a non-HP terminal and will not use HP escape sequences necessary to
handle some of the special display enhancements NetMail/3000 usually uses. This occurs because
NetMail/3000 by default will only check for HP terminals (by issuing a special proprietary HP
terminal escape sequence) if the user’s terminal is configured as the default terminal type (term-
type 10). If you are using some other terminal type but are still using an HP terminal and want to
take full advantage of the display enhancements NetMail/3000 uses, issue the following MPE
command before running NetMail/3000:
:SETJCW NETMAILHPTERM=1
This will override the terminal type checking and force NetMail/3000 to go ahead and
issue the necessary escape sequences to recognize HP terminals (or emulators).
In addition, you can utilize NetMail/3000’s MENU interface on many non-HP terminals.
To do so, you will need to set a JCW (job control word) identifying the terminal type you are
using before you run NetMail/3000. The following lists the supported terminal types:
For the following terminal types: Enter the following command:
DEC VT52 :SETJCW term,5
DEC VT100 :SETJCW term,6
DEC VT220 :SETJCW term,10
DEC VT52k :SETJCW term,11
DEC VT100k :SETJCW term,12
DEC VT220k :SETJCW term,13
DEC VT320 :SETJCW term,14
WYSE-50 :SETJCW term,7
WYSE-30 :SETJCW term,15
IBM 3101 :SETJCW term,20
ADDS Viewpoint :SETJCW term,17
Televideo 910 :SETJCW term,18