Filter
Top Products
A card in the printer has been replaced
Main Logic’s S/N is 41-MVT02
Interface Card’s S/N is 41AAVT50
Check the serial number (S/N) of the
printer. The S/N is located next to the
document insert station and on the
bottom of the printer.
If S/N matches one of the above, please
update the card with the incorrect S/N.
If S/N does not match one of the above,
Refer to the Hardware Service Manual.
To select a sub-menu or test:
FIRST, Press the paper feed button
the indicated number of
times.
THEN, press again and hold
button down at least 1 second
to confirm selection.
OPTIONS.......... Press
1. Main Logic Update Menu....1
2. Interface Card Update Menu..2
3. Continue without updating . . 3
To exit Off-line setup, open printer cover.
If you select option 1, the following message prints:
Main Logic Card Update Menu
Data will be copied from the
interface card to the main logic
Printer will reset when update is done.
To update the Main Logic Card,
Press the paper feed button
To Exit without updating, Open Printer Cover.
If you select option 2, the following message will print:
Interface Card Update Menu
To update the Interface Card,
Press the paper feed button
Data will be copied from the
main logic to the Interface Card.
To Exit without updating,
open printer cover
Selecting Option 3. Continuing without updating could produce unexpected
results.
Storing a new serial number in the firmware
For proper printer operation, the firmware must correlate the serial number of the
printer with the serial number of the logic card. When you replace either the logic
card or the interface card, the serial number is restored into the new card.
However, if both cards are replaced, you must store the correct serial number in
the firmware.
For more information, see the IBM Retail Store Solutions support Web site at
www.ibm.com/solutions/retail/store/support/.
Chapter 7. Tests and diagnostics 105