Filter
Top Products
station or document insert station by a preset amount, until the document
exits the feed rollers. If a cutter is available at the station (CR station only),
it cuts the paper.
Print and feed paper n lines
Syntax:
ESC d n or X'1B64;n'
Where:
n Specifies the number of line-feeds.
Purpose:
Prints data in the print buffer and feeds the paper by the amount specified
in this command.
Print and feed paper using minimum units
Syntax:
ESC J n or X'1B4A;n'
Where:
n Specifies the line feed steps.
In the receipt station: 1 in. = 204 steps (1 mm = 8 steps).
In the document portrait station: 1 in. = 51 steps (1 mm = 2 steps).
In the document landscape station: 1 in. = 127 steps (1 mm = 5
steps).
Note: Line spacing dimension is approximate. For the impact printer in
portrait mode, the actual line spacing must be calculated using 51
steps per inch.
Purpose:
Prints data in the print buffer and feeds the paper by the amount specified
in this command.
Print graphic messages
Select and print a graphics (logo) command
This command can be used to print signature captures at the printer.
1. Capture the signature as a bitmap.
2. Convert the bitmap to a series of graphics (logo) messages.
3. Hold the buffer.
4. Send the graphics messages to the printer.
5. Release the buffer.
Syntax:
ESC * d w h data or X'1B2A;d;w;h;data'
Where:
d Dot density.
00 Normal Print - 200 dpi in the receipt station, 150 dpi in the
document station.
Chapter 2. Communication parameters 65