Filter
Top Products
Remarks:
This is not an exact ratio. The image will get as close as possible to the
ratio. However, the maximum width of an image is 12 columns and the
maximum height is 90 rows.
Enable PDF417 truncation
Syntax:
GS T n or X'1D;54;n'
Where:
n Whether to enable truncation
0 Disable truncation.
1 Enable truncation.
Default:
n=0
Remarks:
Truncated PDF generates a symbol with the right row indicator and stop
pattern replaced by a single width bar. There is a slight degradation in
decode performance if truncation is enabled, which allows more data to fit
in the image width.
Print character commands
These commands should be sent after ASCII data is sent to the printer and is being
held in the print buffer. Any of these commands will increment the line count by 1.
(See “Status byte 6” on page 91 and “Reset line count” on page 77.)
Print and line feed
Syntax:
LF or X'0A'
Purpose:
Prints data in the print buffer and feeds the paper by a preset amount.
Print and line feed
Syntax:
CR or X'0D'
Purpose:
Prints data in the print buffer and feeds the paper by a preset amount.
Remarks:
For applications that send both this command and LF (print and line feed
command), and when only one line feed is required, the printer can be set
to ignore this command. See MCT #30 (0x1e) in Table 8 on page 31. The
default is a line feed.
Print, form feed, and cut the paper (FF)
Syntax:
FF or X'0C'
Purpose:
Prints data in the print buffer and feeds the paper in the customer receipt
64 SureMark 4610 Printers : Programming Guide for Models 1xR and 2xR