Filter
Top Products
Remarks:
If you select double-width printing, the space to the right of each character
is doubled.
Set or cancel rotated characters
Syntax:
ESC V n or X'1B56;n'
Where:
n=00 Cancel Rotated Characters
n=01 Set Rotated Character
Default:
n=00
Remarks:
Rotation is 90 degrees clockwise. This command is supported only in the
thermal print station.
Set print station parameters
Syntax:
ESCc1n or X'1B63;31;n'
Where:
n Specifies the print station.
Bit # ↓ Station
LSB 0 Reserved
1 Customer Receipt Station
2 Document Station - Portrait Mode
3 Document Station - Landscape Mode
4 Reserved
5 Reserved
6 Reserved
7 Reserved
Purpose:
This command is used for setting the line spacing, margins, and tabs.
Remarks:
More than one station can be selected at the same time if the settings are
common to all of the selected stations.
Default:
n = 02 (customer receipt station)
Select 1/8-inch line spacing
Syntax:
ESC 1 or X'1B31'
Remarks:
In the thermal (receipt) station this would set line feeding to 26 steps/line.
In the impact (document - portrait) station this would be set to 6
steps/line.
Chapter 2. Communication parameters 43