Filter
Top Products
Delay=y×0.1seconds
Defaults:
x=02y=03
Remarks:
Ify=0,theprinter does not grab the document. The operator must use
the document feed button to pull the document into the printer.
Ifx=0,theprinter never sends error status if no print data is sent to the
document station.
Select character for reprinted lines.
Status sent to system
Syntax:
ESC ) n or X'1B29;n'
Where:
n Selects the function.
Bit # ↓ Function Bit=0 Bit=1
LSB 0 Print Buffer Empty/Full Yes No
1 Reserved Yes No
2 Front Document Sensor Change Yes No
3 Top Document Sensor Change Yes No
4 After status byte 6 is incremented or
status byte 3, bit 7, is set
Yes No
5 Cash Draw Sensor Change Yes No
6 Key In Use Yes No
7 Cover Open Yes No
Default:
0x00
Remarks:
Bit 4 can be used in place of the command complete. When the buffer is
empty, the system can assume that everything stored in the printer has
been completed. To enable these status messages, unsolicited status must
be enabled. See “Asynchronous (real-time) commands” on page 74.
Select character for reprinted lines
Syntax:
ESC + n or X'1B2B;n'
Where:
n The ASCII representation of the character printed in the first
character position on the print line when recovering from a home
error. This occurs in impact print stations only.
Default:
n = 2A hex (This is an asterisk (*) in most code pages.)
Remarks:
The value is stored to printer memory to prevent loss when the printer is
reset. The default value after the reset is the value last sent.
50 SureMark 4610 Printers : Programming Guide for Models 1xR and 2xR
|
|
|
|
|