Filter
Top Products
Installing the front cover and front door on a stand-alone 8202-E4B or 8205-E6B
system
Use this procedure to install the cover to access components or perform service.
To install the front cover and front door, complete the following steps.
1. Align the cover (A) until the two cover tabs are seated into the slots on the base plate (B), as shown
in the following figure.
2. Rotate the cover up and towards the system until the release latch is seated into its respective slot.
The cover has an indentation where you can hold onto it more easily.
Figure 43. Removing the front cover
52 Power Systems: Power supplies for the 9117-MMB or 9179-MHB