Filter
Top Products
9. If you have other options to install in this blade server, do so now;
otherwise, close the blade server cover and install the blade server in the
BladeCenter unit. See the Installation and User’s Guide for your blade server
for instructions.
10. Turn on the blade server; then, set up a command session:
v If your blade server supports local console connection through the
management module switch control of the keyboard/mouse/video to
this blade server. See the Installation and User’s Guide for your blade
server for instructions.
v If your blade server does not support local console connection, see the
Installation and User’s Guide for your blade server for instructions about
how to set up a command session with the blade server.
11.
If your blade server is an IBM BladeCenter JS20, skip this step. This step,
including the example text, only applies if your blade server is an IBM
BladeCenter HS20 or HS40 and the IBM Eserver BladeCenter Fibre
Channel Expansion Card is installed in your blade server.
If the information displayed on the monitor screen is similar to the
following text, update the BIOS or firmware code if necessary, and install
the expansion card device drivers. For more information, see Chapter 3,
“Updating the I/O expansion card BIOS or firmware code and NVRAM
code and installing device drivers,” on page 15. If the information
displayed on the monitor screen is not similar to this text and you have
checked the expansion card configuration, go to Chapter 6,
“Troubleshooting,” on page 27 for problem-solving information.
QLogic Corporation
QLA2312 PCI Fibre Channel ROM BIOS Version X.XX
Copyright (C) QLogic Corporation 1993-2003 All Rights Reserved.
www.qlogic.com
Press <Ctrl+Q> for Fast!UTIL
BIOS for Adapter 0 is disabled
ROM BIOS not installed
14 Installation and User’s Guide for HS20/HS40 and JS20 Fibre Channel expansion cards