Filter
Top Products
This task can be run directly from the AIX command line. See the following command
syntax: diag -c -d
RAIDadapterName
-T "certify {-l
chID
| -A}"
Flag Description
-c No console mode
-d Specifies the RAID adapter to which the disk is attached
-T Specifies the certify task and its parameters
-I Specifies physical Disk channel/ID (example: -l 27)
-A All disks
Change Hardware Vital Product Data
Use this service aid to display the Display/Alter VPD Selection Menu. The menu lists all
resources installed on the system. When a resource is selected, a menu displays that
lists all the VPD for that resource.
Note: The user cannot alter the VPD for a specific resource unless it is not
machine-readable.
Configure Dials and LPF Keys
Note: The Dials and LPF Keys service aid is not supported in standalone mode
(CD-ROM and NIM) on systems with 32 MB or less memory. If you have
problems in standalone mode, use the hardfile-based diagnostics.
This service aid provides a tool for configuring and removing dials and LPF keys to the
asynchronous serial ports.
This selection invokes the SMIT utility to allow Dials and LPF keys configuration. A TTY
must be in the available state on the async port before the Dials and LPF keys can be
configured on the port. The task allows an async adapter to be configured, then a TTY
port defined on the adapter. Dials and LPF keys can then be defined on the port.
Before configuring Dials or LPF keys on a serial port, you must remove all defined
TTYs. To determine if there are any defined TTYs, select List All Defined TTYs. Once
all defined TTYs have been removed, then add a new TTY and configure the Dials or
LPF keys.
Configure ISA Adapter
This task uses SMIT to identify and configure ISA adapters on systems that have an
ISA bus and adapters.
Diagnostic support for ISA adapters not shown in the list may be supported from a
supplemental diskette. You can use the Process Supplemental Media task to add ISA
adapter support from a supplemental diskette.
100 Eserver pSeries 690 User’s Guide