Filter
Top Products
Step 10
There is a problem with the keyboard.
Go to the problem-determination documentation for this type of terminal. For more
information, refer to the
Hardware Management Console for pSeries Maintenance
Guide
.
Step 11
1. If the terminal type has not been defined, use the Initialize Terminal option on the
Function Selection menu to initialize the operating system environment before you
can continue with the diagnostics. This is a separate and different operation from
selecting the console display.
2. Select Diagnostic Routines.
3. Press Enter.
4. In the following table, find the menu or system response you received when you
selected Diagnostics. Perform the action listed in the Action column.
System Response Action
The Diagnostic Mode Selection menu is displayed. Select Problem Determination and go to “Step 12”
on page 149.
The Missing Resource menu is displayed. Follow the displayed instructions until either the
Diagnostic Mode Selection menu or an SRN is
displayed.
If the Diagnostic Mode Selection menu is displayed,
select Problem Determination and go to “Step 12” on
page 149.
If you get an SRN, record it, and go to “Step 14” on
page 149.
The New Resource menu is displayed. Follow the displayed instructions.
Note: Devices attached to serial ports S1 or S2 do
not appear on the New Resource menu.
If the Diagnostic Mode Selection menu is displayed,
select Problem Determination and go to “Step 12” on
page 149.
If you get an SRN, record it, and go to “Step 14” on
page 149.
If you do not get an SRN, go to “Step 16” on
page 150.
The system does not respond to selecting
diagnostics.
Go to “Step 10”.
148 Eserver pSeries 690 User’s Guide