Filter
Top Products
Use this option to change the I/O type of the primary I/O book after a service
action or configuration change if the I/O type is incorrect. If this option is chosen,
you will be asked to make the following entries:
- For the I/O drawer address, type 1.
- For the I/O type, type 98.
If either value is not valid, a failure message displays on the console. Press Enter
to return to the Power Control Network Utilities Menu.
v LED Control Menu
This menu displays the state of the processor subsystem disturbance or system
attention LED and the fault/identify LED on the I/O subsystem(s). Use this menu to
toggle the attention/fault LEDs between identify (blinking) and off. Option 1 is
available only when the system is in the error state (the CEC is powered on and the
service processor menus are available). Option 1 is not available when the system is
in standby.
An example of this menu follows:
LED Control Menu
1. Set/Reset Identify LED state
2. Clear System Attention Indicator
98. Return to Previous Menu
0>
The processor subsystem disturbance or system attention LED is located on the
operator panel in the media drawer. The I/O drawer fault/identify LED is located on
the front of each I/O subsystem.
If option 1 is selected, a list of location codes of the I/O subsystems and the CEC
drawer displays. The screen will be similar to the following:
38 Eserver pSeries 690 User’s Guide