Filter
Top Products
Call-In/Call-Out Setup Menu
Note: The information in this section regarding the configuring of serial ports, and
modems attached to those serial ports, applies only to the serial ports (S1 and
S2) on the primary I/O book (location U1.18-P1-H2). These serial ports are
normally used for call-in and call-out.
Call-out is disabled in partitioned systems. The call-out function is normally
handled by the Service Focal Point application running on the HMC.
None of these menus are applicable to the serial ports, or modems attached to
those serial ports, on the hardware management console (HMC).
CALL-IN/CALL-OUT SETUP MENU
1. Modem Configuration Menu
2. Serial Port Selection Menu
3. Serial Port Speed Setup Menu
4. Telephone Number Setup Menu
5. Call-Out Policy Setup Menu
6. Customer Account Setup Menu
7. Call-Out Test
NOT supported in LPAR mode.
98. Return to Previous Menu
99. Exit from Menus
0>
v Modem Configuration Menu, see “Modem Configuration Menu” on page 45.
v Serial Port Selection Menu, see “Serial Port Selection Menu” on page 46.
v Serial Port Speed Setup Menu, see “Serial Port Speed Setup Menu” on page 47.
v Telephone Number Setup Menu, see “Telephone Number Setup Menu” on page 47.
v Call-Out Policy Setup Menu, see “Call-Out Policy Setup Menu” on page 49.
v Customer Account Setup Menu, see “Customer Account Setup Menu” on page 50.
v Call-Out Test tests the configuration after the modem is installed and configured
correctly.
Note: If the system is running in partition mode, the call-out option is disabled.
44 Eserver pSeries 690 User’s Guide