Filter
Top Products
Chapter 2. Configuring the BladeCenter T unit
The BladeCenter T unit automatically detects the modules and blade servers that
are installed and stores the vital product data (VPD). When the BladeCenter T unit
is started, the management module automatically configures the remote
management port on the management module, accessed through the LAN module
on the rear of the BladeCenter T unit, so that you can configure and manage the
BladeCenter T unit and blade servers. You configure and manage the BladeCenter
T unit remotely, through the management module, using the Web-based user
interface.
Note: There are two ways to configure the switch modules; through the
management-module Web interface, or through an external switch-module
port enabled through the management module, using a Telnet interface or a
Web browser. See the documentation that comes with the switch module for
more information.
For the active management module to communicate with the I/O modules in the
BladeCenter T unit, you must configure the IP addresses for the following internal
and external ports:
v The external Ethernet (remote management) port on the management module,
accessed through the LAN module on the rear of the BladeCenter T unit (see
“Configuring the external Ethernet port” on page 28 for instructions). The initial
management module autoconfiguration enables the network management station
to connect to the management module to configure the port completely and to
configure the rest of the BladeCenter T unit.
v The internal Ethernet port on the management module for communication with
the I/O modules (see “Configuring the internal Ethernet port” on page 29 for
instructions).
v The management port on each switch module provides for communication with
the management module. You configure this port by configuring the IP address
for the switch module (see “Configuring management ports on I/O modules” on
page 29 for instructions).
Note: Some types of I/O modules, such as the pass-thru module, have no
management port.
See
the documentation that comes with the I/O module to determine what else you
must configure in the I/O module.
To communicate with the blade servers for functions such as deploying an operating
system or application program over the network, you must also configure at least
one external (in-band) port on an Ethernet switch module in I/O-module bay 1 or 2.
See “What to configure” on page 29 for information about configuring external ports
on Ethernet switch modules.
The management module supports the following Web browsers for remote access.
The Web browser that you use must be Java
™
-enabled, must support JavaScript
™
1.2 or later, and must have the Java Virtual Machine (JVM) 1.4.1 or later Plug-in
installed. The JVM Plug-in is available at the Java Web site at http://www.java.com/.
v Microsoft
®
Internet Explorer 5.5 (with latest Service Pack installed), or later
v Netscape Navigator 4.72, or later (version 6 is not supported)
v Mozilla version 1.3, or later
© Copyright IBM Corp. 2004 23