Filter
Top Products
Slight angle toward
the rear of the system
11. Hold the air damper angled slightly towards the back of the server; then, pull
the air damper towards the center of the chassis until the pins on the air
damper snap into the slots located on the back side of the air damper slot.
Rock the air damper up and down while pulling on it to help it seat.
12. Remove the tape used to hold the air dampers open in step 7 on page 83.
13. Install the power modules and fillers in the bays at the front of the unit (see
“Installing a power module” on page 48).
14. Install the management modules and fillers from the bays at the front of the
unit (see “Installing a management module” on page 53).
15. Install the media tray at the front of the unit (see “Installing the media tray” on
page 50).
16. Install the server blades and fillers from the front of the unit (see “Removing
and installing a blade server or filler module” on page 64).
17. Start up the system (see “Starting the BladeCenter T unit” on page 19).
84 BladeCenter T Type 8720 and 8730: Hardware Maintenance Manual and Troubleshooting Guide