Filter
Top Products
1
Rubber feet for shelf or table placement.
Brackets and screws for standard
19-inch equipment rack placement.
Quick Start
1. Install the Express 10/100 Switch in a rack or on a shelf or table and plug the
cord in. If you’re in Europe or Asia, or any other country that has a 220-volt
electrical system, set the power supply switch to 230 (115 is the default).
Otherwise, leave the switch set to 115. Turn the power on.
2. Connect the network devices to the switch.
3. Check the LEDs for power and links.
Next steps (Optional)
• Continue to the next page if you want to configure the switch to work with an SNMP-compliant
Network Management System (NMS).
• See Chapter 2 if you want to use the Console Manager to change port configurations (set a port for
full duplex or manually set the speed), assign an IP address, or check port statistics.
Crossover cables
to hubs or other
switches.
Straight-through cables
to servers/workstations.
Blinks every two seconds.
Lights briefly while the switch
performs self-tests.
Always on.
Lights when a 100BASE-TX
device is attached.
Lights when a
device is attached.
Cabling Guidelines
at 10 Mbps at 100 Mbps
Server/ CAT 3, 4, or 5 CAT 5
Workstation straight-through straight-through
to Switch
Hub to CAT 3, 4, or 5 CAT 5 crossover
Switch crossover
Switch to CAT 3, 4, or 5 CAT 5 crossover
Switch crossover