Filter
Top Products
66
CHAPTER 3
Intel Express 10/100 Fast Ethernet Switch
set-port-dplex
set-port-dplex <port_number> {half|full}
Specifies whether the given port is in full-duplex or half-duplex
(standard Ethernet) mode. The default is half-duplex. You must set
the port speed to either 10 or 100 (
asense is the default) before setting
a port to full-duplex.
SYS_console> set-port-dplex 2 full
Port configured in <full_duplex> mode
Parameter change in NVRAM OK
set-speed-sel
set-speed-sel <port-number> {asense|10|100}
Sets a port’s speed to 10, 100, or auto detect. The default is asense.
set-port-fctrl
set-port-fctrl <port-number> {on|off}
Turns the flow control feature on or off for the specified port. The
default is on.
If the port is in full-duplex mode, flow control is turned off. Flow
control or full duplex (or neither) can be active, but not both. One
exception is between two Express 10/100 Switches.
SYS_console> set-port-fctrl 2 off
Port 2 - flow control <off>
Parameter change in NVRAM OK
Statistics Commands
This section contains instructions for displaying switching statistics
using the Console Manager. The following commands provide full
physical layer information as well as inter-port switching statistics.
See Chapter 2 for definitions of individual statistics.
Under heavy traffic loading conditions, the Console Manager may
understate the Ethernet statistical counts. You can also use a protocol
analyzer to monitor the segment the port is attached to. See step 8 on
page 72 for configuration details.
clr-cnt
Clears (resets) the Ethernet and bridging statistical counters.